Cleaning And Care - BRAYER BR3401 Bedienungsanleitung

10 EN
STEP 5
• In the final stage of hair styling remove the installed
attachment comb (10, 11, 12 or 13) from the clipper,
turn the blades of the clipper towards the hair and trim
hair on the temples and neck carefully. Before creating
the contour, comb the hair above ears. Slightly bend
back the person's ear so it will not get in the way of
cutting hair. Do not press the clipper strongly, there is
danger of injuries or cuts when open blades come in
contact with skin.
• Notes: — without using the attachment combs (10,
11, 12 or 13), for a short haircut, you can change the
remaining hair length in the range from 1.0 mm to 1.9
mm, to change the remaining hair length move the
blade shifter (5) (pic. 5).
• After you finish cutting hair, switch the hair clipper off by
pressing the button (4) «
• Remove the installed attachment comb (pic. 4), clean it
from hair, remove the blade block (6) (pic. 6) and clean
it (pic. 7) with the brush (15). Clean the inner cavity
under the blade block (6) (pic. 8).
• Lubricate the blade block (6) (pic. 2).
• Install the blade block (6) back to the installation place
(pic. 9).

CLEANING AND CARE

• After you finish using the hair clipper, switch it off. If the
hair clipper is powered by the adapter (9), unplug the
power adapter (9) and disconnect the connecting cord
jack of the adapter from the hair clipper body (pic. 1a).
».
• Remove the installed attachment comb (10, 11, 12 or
13) (pic. 4) and clean it from hair with the brush (15).
• Remove the blade block (6) (pic. 6).
• Clean the blade block (6) (pic. 7) and the clipper
inner cavity under the blade block (6) with the brush
(15) (pic. 8). Do not wash the blade block (6) and the
inner cavity of the hair clipper body under a water jet.
• Clean the hair clipper body with a soft, slightly damp
cloth, and then wipe it dry.
• Do not use abrasives or solvents to clean the
hair clipper body, the power adapter (9) and the
attachment combs (10, 11, 12, 13).
• Never immerse the hair clipper, the power adapter
(9) and the power adapter cord into water or other
liquids.
• Lubricate the blade block (6) after every use with the
lubricating oil (14).
STORAGE
• Before taking the hair clipper set away for storage,
clean the hair clipper body, the blade block (6) and
the attachment combs (10, 11, 12, 13).
• Lubricate the blade block (6) with lubricating oil (14).
• Keep the hair clipper set in a dry cool place out of
reach of children and disabled persons.