Troubleshooting - EINHELL GE-LC 18/25 Li Originalbetriebsanleitung

11. Troubleshooting

Danger!
Before troubleshooting, switch off the equipment and pull out the battery.
The table below contains a list of fault symptoms and explains what you can do to remedy the problem if
your tool fails to work properly. If the problem still persists after working through the list then please con-
tact your nearest service workshop.
Cause
Chainsaw does not - Quick stop brake has been trigge-
work at all red
- No power supply
Chainsaw operates - Loose connection (external)
intermittently - Loose connection (internal)
- ON/OFF switch defective
Saw chain dry - No oil in the tank
- Oil tank cap breather blocked
- Oil outlet blocked
Chain brake does - Problem with the switch mecha-
not work nism in the front hand guard
Chain/guide rail hot - No oil in the tank
- Oil tank cap breather blocked
- Oil outlet blocked
- Blunt chain
Chainsaw judde- - Chain tension too loose
ring, vibrating or not - Blunt chain
sawing properly - Worn chain
- Saw teeth pointing in the wrong
direction
Anl_GE_LC_18_25_Li_Kit_SPK9.indb 31 Anl_GE_LC_18_25_Li_Kit_SPK9.indb 31
GB
Fault
- Pull the hand protection back to the
normal position.
- Check the power supply.
- Consult a specialist workshop.
- Consult a specialist workshop.
- Consult a specialist workshop.
- Fill up with oil.
- Clean the oil tank cap.
- Clear the oil outlet.
- Consult a specialist workshop.
- Fill up with oil.
- Clean the oil tank cap.
- Clear the oil outlet
- Re-sharpen or replace the chain.
- Adjust the chain tension.
- Re-sharpen or replace the chain.
- Replace the chain.
- Reinstall the saw chain with the
teeth facing in the correct direction.
- 31 -
Remedy
16.10.2020 10:38:55 16.10.2020 10:38:55