Conformity Declaration - Melinera IAN 330606_2001 Bedienungsanleitung

GB/IE
could become scratched by the product 1 .
NOTE!
The operation/connection module 3 is located at
the bottom left of the product 1 on the rear side.
2. Insert the connector plug 2a of the mains power
adapter 2 into the input socket 4 on the opera-
tion/connection module 3 , see Fig. B1.
3. Insert the mains plug 2b of the mains power
adapter 2 into a correctly installed wall outlet,
see Fig. B2.
NOTE!
The wall socket should be easily accessible so that
the mains power adapter can be pulled out quickly
if necessary.
Only applies for 330606-20-C:
Place the figures 6c with the magnetic foot and felt
gliders on the ice rink 7 . As soon as you approach
one of the magnets located under the ice rink 7
a figure, the figure will be magnetically attracted.
Then place the figure down at this point.
The product 1 is now ready to use.
6.2 Use
On/off switching, activate moving parts,
music and timer (C)
You can switch the following modes with the switch
5 on the operation/connection module 3 :
ON1: Light + music + motion + timer on
ON2: Light + music + motion + timer on
OFF: switched off
Timer function
The product 1 is equipped with a timer function.
When one of the "ON1" or "ON2" modes is se-
lected, the timer function is turned on. If the timer is
on, the product 1 will automatically switch off after
6 hours. After another 18 hours, the product
automatically switch back on. As long as the switch
5 is left in the "ON1" or "ON2" position, this daily
rhythm will be repeated.
NOTE!
- The product 1 offers 8 Christmas melodies. If the
"ON1" mode is selected, these 8 melodies are
played back one after the other in a continuous
loop.
14
- No direct selection of melodies can be made.
- The speaker is located on the bottom side of the
product 1 . Therefore, do not place the product
on a surface that is too soft. The sound will other-
wise be too muffled.
NOTE!
Risk of material damage
- Ensure that the moving parts 6 /
the product 1 are not restricted or impeded in
their range of movement. There is a risk of material
damage.
- Remove any objects in the movement radii before
start-up.
7. Cleaning & care instructions
WARNING!
!
Risk of injury!
Before cleaning, you must discon-
nect the power plug. There is a risk
of electric shock!
with - clean only with a feather duster
- contaminants may be blown away
- do not use any strong detergents and/or chemi-
cals
- do not immerse in water
- store in a cool, dry place and protected from UV
light
Only applies for 330606-20-C:
- clean the felt gliders of the figures
with a damp, lint-free cloth
- Storage: wrap the figures 6c individually in a soft
paper or cloth and place them with the product

8. Conformity declaration

This device complies with the fundamental
requirements and other relevant regula-
tions of the European Electromagnetic
Compatibility Directive 2014/30/EU and the RoHS
1 will Directive 2011/65/EU. The complete original con-
formity declaration is available from the importer.
9. Disposal
Disposal of the packaging
The packaging and operating in-
structions are made of 100 % en-
vironmentally friendly materials,
04
which you may dispose of at local
LDPE
recycling centres.
Disposal of the product
The product may not be disposed of with nor-
1 mal household waste. Please find out about
disposal options for the product from your lo-
cal authority or town administration.
10. Warranty
Warranty from TRADIX GmbH & Co. KG
Dear customer, the warranty on this product is 3
6c (Fig. A) of years from the purchase date. In the event of defects
in this product, you are entitled to exercise your stat-
utory rights against the seller of the product. These
statutory rights are not limited by our warranty de-
scribed in the following.
11. Warranty conditions
The warranty begins on the date of purchase. Please
keep the original receipt. This document is required
as verification of the purchase.
If a material or manufacturing defect arises within
three years from the purchase date of this product,
the product will be repaired or replaced, as per our
choice, at no charge to you. This warranty service re-
quires the submission of the purchase receipt and the
defective product within the three-year period and
a short written description of the defect and when
it arose.
If the defect is covered by our warranty, the repaired
or a new product will be returned to you. The war-
ranty period does not restart with the repair or re-
placement of the product.
Guarantee period and statutory claims for
6c regularly
defects
The guarantee period will not be extended by the
warranty. This also applies to replaced and repaired
parts. Damage and defects which may possibly al-
ready exist upon purchase must be reported imme-
diately after unpacking. After the guarantee period
has expired, required repairs shall be subject to a
charge.
Scope of guarantee
The device has been carefully produced under strict
quality guidelines and conscientiously inspected pri-
or to delivery. The guarantee service applies to mate-
rial or manufacturing faults. This guarantee does not
extend to product parts, which are exposed to nor-
mal wear and tear and can therefore be regarded
as wearing parts or to damage to fragile parts, e.g.
switches, battery packs or which are made of glass.
This guarantee shall lapse, if the product is damages,
not used properly or maintained properly. For prop-
er use of the product, all of the instructions in the op-
erating instructions must be precisely complied with.
Purposes and actions, which are dissuaded from or
warned about in the operating instructions must be
avoided.
The product is only intended for private and not
commercial use. In the case of abusive and improper
handling, use of force and with interventions, which
are not performed by our authorised service branch,
the guarantee shall lapse.
Processing in the case of a guarantee
claim.
To ensure quick processing of your concern, please
follow the instructions below:
- Please have the till receipt and article number
available (e.g. IAN 330606_2001) as proof of
the purchase.
- You can find the article number on the rating plate
on the product, as an engraving on the product,
the title place of your instructions (bottom left) or
the sticker on the back or underside of the product.
- If malfunctions or other defects occur, first contact
the service department below by telephone or
e-mail.
- You can then send a product that has been record-
ed as being defective, including the proof of pur-
chase (till receipt) and stating what the defect is
and when it occurred, postage-free to the service
address provided to you.
On www.lidl-service.com, you can download these
an many other manuals, product videos and instal-
lation software.
With this QR code, you can directly
reach the Lidl Service website (www.
lidl-service.com) and can open your
operating instructions be entering the
article number (IAN)330606_2001.
12. Distributor
TRADIX GmbH & Co. KG
Schwanheimer Str. 132
DE-64625 Bensheim/GERMANY
13. Service address
TRADIX SERVICE-CENTER
c/o Teknihall Elektronik GmbH
Breitefeld 15
DE-64839 Münster/GERMANY
GB/IE
15