Maintenance - S&P RESPIRO 100 Handbuch

REPLACEMENT OF REMOTE CONTROL BATTERY
After a long period of use, the remote control's battery may need replacement.
The battery should be replaced when the product no longer responds to the com-
mands sent by the remote control.
The battery model to purchase is CR2025 3V.
As in the image on the right press the lever inwards on the remote control (1), and
extract the battery support by pulling it towards you (2).
After taking out the run-down battery, dispose of it in the appropriate containers
as defi ned by the regulations in your country. Replace it with a new battery of the
same model, positioning it as in the image on the right.
Re-insert the battery support with the new battery.

MAINTENANCE

All the device's maintenance operations are exclusively aimed at qualifi ed staff.
Make sure that the room's mains network is disconnected before carrying out maintenance operations.
Once installed, the product's components should be arranged as shown in the above image.
1) INDICATION OF MAINTENANCE PERIOD
We advise cleaning the fi lters (8) and the ceramic exchanger (7) every 3 months.
We advise changing the fi lters every 2 years. Contact your dealer for delivery of replacement fi lters.
1a) RESPIRO 100/RESPIRO 150
This version does not have an alarm for cleaning/replacement of fi lters.
1b) RESPIRO 100 RD/RESPIRO 150 RD
Every 2000 hours of operation the indicator light at the bottom right will emit a continuous red light signal. During the
alarm, each remote control, except for the fi lter reset combination, will be disabled. The product will continue to operate
with the last command received.
Clean the exchanger and the fi lters as specifi ed in the paragraph. Replace the fi lters when necessary.
2) CLEANING OF FILTERS AND EXCHANGER
Remove the main unit (1+2+3) from the wall using a fl at-head screwdriver to actuate the hook placed bottom centre of the
unit as shown below.
39