BTI HV-R 250M Bedienungsanleitung Seite 15

Working with receiver
In the case of HV-R 250M a laser receiver is included.
1
10
6
9
8
Receiver on: Press key 15
Receiver off: Press button 15 long (> 2 sec)
Adjusting the volume: Press button 15 repeatedly
-> toggles between Loud / Quiet / Off
Set display accuracy: Press key 16 repeatedly
-> toggles between coarse / middle / fi ne
Activate / deactivate LEDs: Press button 16 long (> 2 sec)
1 2 3 4 5 6
15
16
7 1 Magnet
2 LED (orange)
3 LED (green)
4 LED (red)
5 Laser receiving fi eld
6 Marking notch
7 Holder
8 Keypad
9 Level vial
10 Display*
11 Type plate with serial number
12 Screw for holder
13 Speaker
14 Battery compartment
15 On/Off Volume
16 Volume / Operating mode
*An arrow in the display shows
the direction where to move the
receiver.
At the top right of the display
the distance to the reference in
mm is shown.
Prerequisite: The laser beam
must strike the receiver fi eld.
15