Dryer Description
To open the door
Press and release the front
Control panel
Programmes Guide
The START/CANCEL button
programme. When you press this button there will be
one beep and the progress lights will flash to confirm
the action. If you have not set a programme, the buzzer
will beep four times. When a programme is running,
holding this button in cancels the programme and
stops the dryer (see Start and Programmes).
The OPTION buttons/lights select available options
for your selected programme (see Start and
Programmes). The lights indicate that the option has
been selected.
The Programmes Guide allows you to consult a user
friendly table of the available programmes.
The Empty Water light
container should be emptied. When it is flashing it
indicates that the container is full.
The light will take a few seconds to go out after
Downloaded from
www.Manualslib.com
panel in position shown
Progress or Delay
starts a selected
signals that the water
manuals search engine
The features
Door latch
Condenser cover
Condenser cover handle
(Pull to open)
START/CANCEL
Button
Empty Water
Lights
Light
OPTION
Buttons and lights
replacing the empty container, the dryer must be
running for this to happen (see The Controls).
The On/Off indicator light
is in use or ready to select a programme. If this light
flashes it indicates there is a fault (see Troubleshooting).
The ON/OFF button
this button is pressed, the dryer stops. Press again,
the dryer restarts.
The Progress or Delay lights show you the status of
the programme, or the delay time when they flash.
During a delayed start the lights will flash to show the
delay selected. When (not flashing) they show each
stage of the programme by the corresponding light
turning on (see Start and Programmes).
The PROGRAMMES knob sets the programme:
rotate it until the indicator is pointing to the programme
you want to select (see Start and Programmes).
Rating plate
Water container
Model &
Serial
numbers
Door catch
Air intake
grille
Filter
On/Off
Light
ON/OFF
Button
PROGRAMMES
Indicator
Knob
signals that your dryer
: If the dryer is running and
GB
3