End Of A Charge / Discharge Process; Display Of The Charge / Discharge Data - Multiplex Quad EQ-BID 230 V Bedienungsanleitung

Power Peak® Quad EQ-BID 230 V
is described in Section 7.4.
While charging or discharging, the most important data is stored on the chip/key.
10.

END OF A CHARGE / DISCHARGE PROCESS

The charger automatically finishes a charging or discharging operation precisely at the
correct time. The processor takes into account the charging parameters. The optimum
process is used for each type of battery.

10.1 DISPLAY OF THE CHARGE / DISCHARGE DATA

During a charge or discharge process, the values for that process are constantly shown
Charged or
Status indicator
discharged
Flashing 'F'
capacity
(Finish)
Current battery
Battery
voltage
type
Operating Instructions
First connect the BID chip / KEY to the charger
using the adaptor lead. This automatically causes
the screen display shown here to appear.
If the charging parameters on the chip are OK,
press the ENTER button to prepare the charging/
discharging process. The further procedure is iden-
tical to that used for a manual start. This procedure
in the working display (see Chapter 5.1).
Charge/dis-
charge time
An audible signal will be heard upon
successful conclusion of the charging pro-
cess. As shown in the illustration opposi-
te, the most important data are shown in
the display.
Charge or
discharge
current
19
43
# 30 8196