Zipper Maschinen ZI-COM100-2V5 Betriebsanleitung Seite 24

23 STORAGE
Before storing, clean the machine well, drain off condensation water. Pack the cleaned machine and
store in a dry and clean place.
24 DISPOSAL
Observe the national waste disposal regulations. Do not dispose of the
machine, machine components or operating materials in residual waste. If
necessary, contact your local authorities for information on available disposal
options.
If you purchase a new machine or equivalent from your dealer, the dealer is
obliged in certain countries to dispose of your old machine properly.
25 TROUBLESHOOTING
Handling the machine with the power supply or vessel pressure > ambient pressure up
can lead to serious injuries or even death. Always disconnect the machine from the
power supply and bring vessel pressure to ambient pressure before servicing or
maintenance work and secure it against unintentional or unauthorised reconnection!
If you find yourself unable to carry out necessary repairs properly and/or do not have the required
skills to do so, always consult a specialist to solve the problem.
Trouble
Pressure can no longer be
stored
Engine overheats
Compressor runs but
produces no pressure
Engine will not start
After reaching the escapes
cut-off pressure
Compressed air through
the relief valve und
Pressure switch to reach
the starting pressure
Compressor on frequently
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
W A R N I N G
Possible cause
 Valve seals broken
 low oil level
 dirty air filter
 Clogged air filters
 Defective seals
 Defective valves in the
cylinder head.
 No electricity
 Leaking or defective check
valve
 Check valve is damaged
 Very much condensate in
the pressure boiler
 Overload compressor
Solution
 Replace the seals
 Refill oil
 Clean or replace the air filter
 Clean or replace the old air filter
 Replace the seals
 Replace the valves
 Check the connection to an
existing electrical grid.
 Let the engine cool down and
then drag the red pressure
switch (on / off)
 Clean or replace check valve
insert
 Replace check valve
 Drain condensate
STORAGE
24
ZI-COM100-2V5