Replacing The Lamp; Troubleshooting - AEG DEK6680M Benutzerinformation

3. To mount the filters back follow the
first two steps in reverse order.
Repeat the steps for all filters if
applicable.
4.4 Replacing the charcoal
filter (optional)
WARNING!
The charcoal filter is non-
washable!
To replace the filter:
1. Remove the grease filters from the
appliance.
Refer to "Cleaning the grease filter" in
this chapter.
2. Press the handle of the mounting clip
on the filter panel underneath the
hood (1).
2

5. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
5.1 What to do if...
Problem
You cannot activate the ap-
pliance.
You cannot activate the ap-
pliance.
1
Possible cause
The appliance is not connec-
ted to a power supply or it is
connected incorrectly.
The fuse is blown.
3. Slightly tilt the front of the filter
downwards (2), then pull.
Repeat the first two steps for all filters.
4. To install a new filter, perform the
same steps in reverse order.
In any case, it is necessary to replace the
filters at least every four months.

4.5 Replacing the lamp

This appliance is supplied with a LED
lamp. This part can be replaced by a
technician only. In case of any
malfunction refer to "Service" in the
"Safety Instructions" chapter.
Remedy
Check if the appliance is cor-
rectly connected to the elec-
trical supply.
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.