Specifications - AniOne 1331340 Bedienungsanleitung

REASSEMBLING AND RESTARTING YOUR FOUNTAIN AFTER CLEANING
1. Make sure that the motor flow rate lever is set to the maximum or "+" position (Figure 10).
2. Change the replacement filter (please replace any filter over four weeks old). If using a new replacement filter, first rinse the filter before use.
3. Attach the replacement filter to the pump. Attach the clear tube to the water tube of the pump.
4. Place the assembled pump and filter back inside the bottom bowl and press it down so that the suction cups stick to the bowl (Figure 10). Thread the
pump's power cord through the cylindrical hole in the bottom bowl and put on the rubber cover.
5. Place your finger on the nozzle of the top cover (Figure 11). Please make sure that the upper end of the clear tube lines up with the water spout of the
top bowl and put the top bowl in position (Figure 12).
6. Place the fountain in its desired location. The use of a protective mat is recommended to protect your floor from splashes or drips which may occur
when in use.
7. Fill the unit with approx. 2 litres of water.
8. Plug the power cord into the adapter. Before you plug in the fountain, make sure both the cord and your hands are dry.
9. Please allow 1 to 2 minutes for the pump to start pumping once plugged in.
10. Add water as needed. It is recommended to fill with water up until the boundary line on the lower rim of the cover and to always keep the fountain
filled with water to 1.5cm below the bowl's upper edge.
10 11 12
USAGE TIPS
When being introduced to the AniOne Ceramic Drinking Fountain Flow, your pet may be cautious about this new source of water. After putting the
fountain into operation, allow your pet to get used to it at his or her own pace. Some pets take a few days or sometimes a little longer to begin using it.
Your pet may prefer the fountain to be placed away from their normal feeding area. Try plugging it in somewhere else, like the laundry room,
bathroom or another corner of the kitchen.
DO NOT RUN DRY!

SPECIFICATIONS

Model: AniOne drinking fountain Flow
Power requirements: Pump 5 V - Power plug: 230V
Power consumption: 1 W