Battery Warning - Lupine Betty TL2 Forensic Bedienungsanleitung

3
Operation

Battery warning:

The LEDs on the back of the lamp-head change color to indicate decreasing voltage. When
battery voltage drops below a certain level, the Backlight LED changes from blue to green.
Near the end of the battery's charge, the light turns red.
Safety advisory: When the battery is completely discharged
( all 5 red LEDs blink with a red backlight on), the light will shut
down after flashing a few times.
In such a case, you should be careful.
Note: When permanently operating the lamp
warnings may be issued in very quick sequence.
Battery full or partly low capacity
discharged remaining
20 Betty TL2
at high power, the battery
very low capacity red + red blinking:
remaining battery empty
Reserve power:
When the battery is completely discharged (all 5 red LEDs
blink with a red backlight on), the light will shut down after
flashing a few times. To activate the battery's reserve power,
doubleclick the switch. This will give you a few minutes
more light, whose exact amount depends on the age of your
battery. The light emitted in reserve-power mode is a very low
beam so as to conserve power and keep the light going as
long as possible. The red 5 LEDs slowly flash when reservepo-
wer mode is activated and the backlight will be red.
reserve power has been completely discharged, the light will
shut down – so be careful.
Note: When operating the lamp only with 2 W or
be available.
Warning: Do not switch on the light when the battery is
discharged, as this will invariably damage the battery.
Recharge the battery as soon as possible to avoid a deep
discharged battery.
When the
Reserve power
less, no reserve power will
Betty TL2
3
21