Turning On The Appliance - ROWENTA AIR FORCE RH846301 Bedienungsanleitung

RO_Aspirateur_AIR_FORCE_UPGRADE_903121-02_Mise en page 1 20/12/12 10:17 Page14
Before you use your vacuum cleaner for the first time, you must charge the battery completely
(for about 12 hours)
While the battery is being charged, the Stop/Start button must be in the Stop position (2.a)
• Place the vacuum cleaner near an electric power point.
• Plug the charger in and connect it to the vacuum cleaner using the socket located at the back of
the neck (fig.5).
• The charge signal (4) located at the front of the main body will light. Leave the vacuum cleaner
to charge. Once the charge cycle is completed (after about 12 hours), the light charge signal will
turn off automatically.
The vacuum cleaner can stay connected to the charger permanently, without any hazard. Keep in
mind, however, that if you decide to keep the charger connected it might become slightly hot. This
would be a completely normal phenomenon.
It is advisable to charge the vacuum cleaner immediately after each use in order to always have it
available with a fully charged battery. Thus, you will gain the maximum benefit from its cleaning
and autonomous performance functions. However, in case you plan to be absent for a long period
of time (on vacation, for example), it is advisable to unplug the charger for, in this case, the
autonomous performance function could be diminished due to automatic power loss.
3 • Turning on the appliance
Unplug the charger cord from the vacuum cleaner. If the charger remains connected to both the
power point and to the appliance, the latter will not function. Hold the vacuum cleaner by the
handle and slide the Stop/Start button downwards, towards one of the two following speeds (fig.6):
• « Min » : Used to vacuum clean thick or delicate rugs and carpets (2.b), as well as fragile surfaces.
Please note : always make sure that the wheels located at the back of the base are clean.
• « Max » : Used for optimum vacuum performance on all floor types, and in case of strong dirt
marks (2.c).
Vacuum cleaner running times* for each usage speed (with a fully charged battery):
12 Volts
USING THE ELECTRO-BRUSH
The electro-brush is a rotating, motorized brush that guarantees maximum cleaning effectiveness
by allowing the appliance to suck up dirt and clean in depth. The bristles, located all along the
brush, remove threads, hair and fur that might be caught on the surface of rugs and carpets.
Please note: If the vacuum head adheres too closely to the surface you are cleaning, change the
speed to « Min ».
ATTENTION: Do not vacuum large fragments of broken objects, as they could block and damage
the brush. Do not use the electro-brush on long hair carpets, on animal fur, or on fringes.
REMOVING AND CLEANING THE ELECTRO-BRUSH
ATTENTION: Always turn off the appliance and unplug it before storing or cleaning.
* May vary according to model
Speed 1
« Min »
Up to 25 minutes
Speed 2
« Max »
Up to 15 minutes
EN
14