Installation Instructions: Electrical System For Towing Hitch - Westfalia 321 701 300 107 Einbauanleitung

Installation Instructions:
Electrical System for Towing Hitch
Important notes
Read the installation manual prior to starting work.
The electrical kit should only be installed by qualified personnel.
Caution – Disconnect the battery!
Danger of damage to the vehicle's electronic system. Data which are stored
electronically may get lost.
Read out the fault storage prior to starting work.
Use a closed-circuit current conservation unit if necessary.
Note
During installation special attention has to be paid to the following points:
Cables must not be pinched or damaged.
•
All sealing elements have to be installed properly.
•
The socket gasket has to be positioned on the insulating sleeve and not on the individual
•
wires.
Lay the cables such that they do not rub on the vehicle and are not bent.
•
Do not lay any cables near the exhaust system.
•
When a trailer lamp fails (including direction indicator lights, but not back-up light and rear fog
lamp), this is indicated by the light failure indicator in the instrument cluster. An additional
indicator light (C2) for monitoring the direction indicators on the trailer is not provided in the
vehicle.
When a trailer is used, the rear fog lamp of the traction vehicle is deactivated.
In the case of trailers without rear fog lamp, a rear fog lamp has to be retrofitted.
A socket adapter may only be used in conjunction with a trailer. When the trailer is no longer
used, remove the socket adapter.
Correct trailer operation has to be checked using a trailer or a test instrument with load resistors.
Subject to technical alterations!
10 321 701 391 101 - 002 - 11/11
Installation Instructions:
Electrical System for Towing Hitch
VW Amarok