Functions & Controls - ESX V450.2 Bedienungsanleitung

5-Channel Amplifiers - Functions & Controls
LINE INPUT - Allows to connect the amplifier
with the head unit via RCA cable.
CROSSOVER - OFF / LP / HP Channel 1/2 & 3/4
Position HP - Highpass is activated, the frequency of the speakers is
bounded below. The threshold is from 40Hz to 400Hz adjustable and
is controlled by FREQ ADJUST.
Position OFF - full range output signal.
Position LP - Lowpass is activated, the frequency of the speakers is
bounded above. The threshold is from 40Hz to 400Hz adjustable and
is controlled by the FREQ ADJUST.
CROSSOVER - OFF / LP Channel 5
Position OFF - full range output signal. When you use this setting
the LOW PASS ADJUST control is deactivated.
Position LP - Lowpass is activated, the frequency of the speakers is
bounded above. The threshold is from 40Hz to 400Hz adjustable and
is controlled by the LOW PASS ADJUST.
BASS BOOST Channel 5
Allows to adjust the bass boost from 0dB - 18dB.
PHASE SHIFT Channel 5
Allows to adjust the Phase-Shift from 0° - 180° Degrees.
BASS REMOTE Channel 5
With this switch you can activate (ON) or deactivate (OFF) the
Remote Control. When you have activated the Bass Remote the
BASS BOOST control of the amplifier is out of function.
V 800.5
INPUT GAIN - Allows
to adjust the input level
from the head unit.
25
BASS REMOTE CH5 - Allows to control
Bass Boost via Remote Control from any
location, e.g. from driver's seat. Please
connect the included bass remote here.
STATUS - LED
The LED lights up blue
the amplifier is in
operation-mode.