Start-Up And Use - Lagrange La Bouilloire Bedienungsanleitung

• This kettle was designed solely for boiling water.
• Be careful of the steam that comes out of the spout - it
is very hot.
• Only use the power supply base provided with the
appliance, and keep it clean and dry.
• Before filling the kettle with water, remove it from its
base.
• Check that the cover is properly clip-fastened before
using the kettle to heat water.
• Never remove the cover when heating water, or so
long as there is hot water inside.
• Connect your appliance to a 10/16 A socket fitted with
an earth contact and check that your installation
complies with the standards in force and is compatible
with the power and voltage levels indicated on your
appliance.
• Never place your kettle or its base on a gas or electric
cooking plate.
• Never submerge either the kettle, its base or the cord in
water.
• We recommend you connect the appliance to an instal-
lation that has a device with a residual differential current
with a breaking current that does not exceed 30mA.
• Never move your appliance while it is in operation.
• Before any cleaning operation, unplug the appliance
and let it completely cool down.
• Do not touch the sides (other than the handle) when
the kettle is operating, as they are very hot (there is
a risk of being burnt).
• Never use the kettle without water.
• This appliance is solely for domestic use.

Start-up and use

1 First use
• When unwrapping your appliance, make sure you care-
fully remove all the packing.
• Rinse the inside of your kettle.
• Fill your kettle up to the maximum water mark, boil the
water, and then empty it into the kitchen sink.
• Repeat the operation twice.
2 Start-up
• Remove the cover and fill the kettle with water to the
desired level between the Min. and Max. marks (look at
the window).
• Put the cover back on by clipping it securely into place.
• Place the kettle on its base.
• Plug in the cord.
• Press the On button and the indictor will light up. The
kettle will switch off automatically when boiling tempe-
rature is reached.
• Your kettle is fitted with a filter that will catch calcium
particles.
• Each time you use your kettle, empty it afterwards.
Operation without water:
If you use your kettle without any water in it, it will switch
to safety mode and stop operating. Leave it to cool down
for 15 minutes before using it again.
Do not worry if you find a few drops of water undernea-
th your kettle - this is the result of condensation.
7