Basic Settings; Mechanical Foot Support - B+B Triplex Bedienungsanleitung

TRIPLEX
| Electric Wheelchair
3.3. Contents
Upon receiving the goods, please check the contents for completeness
right away. As standard*, the contents consist of:
• outer package
• electric wheelchair (ready for use incl. 2 batteries)
• VR2 control system (R-Net with electrical adjustable components)
• charging unit
• seat cushion
• instruction manual
*If you ordered accessories, they will be included as well. Please also
check all accessories for completeness.
3.4. Summary
backrest tube
back support
control unit
arm support
sidepanel
seat cushion
lights
Indicators
drive wheel
foot support
castor wheel
44

3.5. Basic settings

It is necessary to adjust the wheelchair to your body size before first use.
This is the only way to ensure a physiologically correct posture allowing
for long drives without tiring. Below you find a description of the basic
settings of the wheelchair. You should carry out these adjustments with
the help of your medical supply dealer. You need a set of 4 mm, 5 mm
and 6 mm Allen keys, a screw driver and ring spanners, 10 and 13.

3.5.1. Mechanical foot support

Length of lower leg support
• The lower leg support can be adjusted from 470 to 550 mm.
• To do so, loosen the two allen screws.
• Adjust to the desired height.
• Tighten the screws again. Use medium-strength Loctite to lock
screws in place.
Make sure to always use two screws for secure
fastening!
Angle of foot support
• The angle of the foot support is adjustable.
• Loosen the screwing at the side of the foot support.
• Adjust to the desired angle.
• Tighten the screw again. Use Loctite 243 to lock screw in place.
Make sure to set the angle only within the marked
range!
01
Bischoff & Bischoff GmbH | 05.10.2020 - Revision: 1
TRIPLEX
Electric Wheelchair |
02
03
45