Before Switching On Your Tv; Power Connection; Connections To The Rf Input Socket; How To Connect Other Devices - AEG CTV 4818 Bedienungsanleitung

Before Switching On Your TV

Power Connection

IMPORTANT: The TV set is designed to op-
erate on 230V AC, 50 Hz.
• After unpacking, allow the TV set to reach the
ambient room temperature before you con-
nect the set to the mains.
Connections To The RF Input
Socket
:

9+)8+)
S@6SÃPAÃUC@ÃUW
• Connect the aerial or cable TV plug to the
RF input socket located at the back of the TV
and connect the cable plug coming out from
the TV out socket located at the devices
(VCR, DVB etc.) to this socket as well.

How To Connect Other Devices

IMPORTANT: Switch off the TV before con-
necting any external device.
Sockets for external connections are at the
back and side of the TV (optional). For con-
nection of other devices via Euroconnector
refer to the manuals of the related devices.
Inserting Batteries In The Remote
Control Handset
• Place the batteries in the right directions as
seen below.
• Remove the battery cover located on the
back of the handset by gently pulling up-
wards from the indicated part.
• Insert two MN2400 AAA or equivalent type
batteries inside.
• Replace the battery cover.
02-ENG-2707W-1546 UK-27 INCH TFT-(CHI MEI)(10 PAGE)-50055817.p65
867G@ÃUWÃ
ENGLISH - 39 -
39
NOTE: Remove batteries from remote con-
trol handset when it is not to be used for a
long period.Otherwise it can be damaged
due to any leakage of batteries.

Switching The TV ON/OFF

To switch the TV on:

Your TV will switch on in two steps:
1- Connect the power supply cord to the sys-
tem. Press On/Off switch at the rear of the
TV. Then the TV switches itself to stand-by
mode and the led becomes red located on
the front of the TV.
2- To switch on the TV from stand-by mode
either:
Press a digit button on the remote control so
that a programme number is selected,
or,
Press “ ”, "-P/CH" or "P/CH+" button at the
top of the TV or press “-P/CH” or “P/CH+”
button on the remote control, so that last
switched off programme is selected.
By either ways the TV will switch on and the
led becomes green.

To switch the TV off:

• Press the “stand-by” button on the remote
control, so the TV will switch to stand-by
mode and the GREEN LED will become
RED,
or,
Press the “ ” button located on the top of
the TV, so the TV will switch off and the
GREEN LED will become RED.
03.08.2004, 17:01