Electrical Interconnection - Hifonics Vulcan VXi1201 Benutzerhandbuch

BEFORE CONNECTING
For the professional installation of a sound system, car audio retail stores offers appropriate wire kits. Ensure a sufficient profile section
(at least 25 mm ), the suitable fuse rating and the conductivity of the cables when you purchase your wiring kit. Clean and remove rust-
2
streaked and oxidized areas on the contact points of the battery and the ground connection. Make sure that all screws are fixed tight after
the installation, because loose connections cause malfunctions, insufficient power supply or interferences.
GND
1
Connect the GROUND terminal with a suitable contact ground point on the vehicle's chassis. The ground wire must be as short
as possible and must be connected to a blank metallic point at the vehicle's chassis. Ensure that this ground point has a stable
and safe electric connection to the negative "–"pole of the battery. Check this ground wire from the battery to the ground point if
possible and enforce it if required. Use a ground wire with a sufficient cross section (at least 25 mm
plus (+12V) power supply wire.
REM
2
Connect the turn-on signal (e.g. automatic antenna) or the turn-on remote signal of your head unit with the REM-terminal of the
amplifier. Use therefor a suitable cable with a sufficient cross section (0,5 mm
headunit.
BATT+12V
3
Connect the BATT+12V-terminal with the +12V pole of the vehicle's battery. Use a suitable cable with a sufficient cross section
(at least 25 mm ) and install an additional in-line fuse. For safety reasons the distance between the fuseblock and the battery
2
should be shorter than 30 cm. Do not set in the fuse into the fuseblock until the installation is accomplished.
FUSE
4
The inserted fuses protect the amplifier from shorts and capacity overload.
X-OVER MODE
PROTECT
LEVEL
LP/BP HP FULL
INSTALLATION INSTRUCTIONS
POWER BASS LEVEL
MIN MAX
CONTROLLER
VXi 1201

ELECTRICAL INTERCONNECTION

ELECTRICAL INTERCONNECTION
GND REM +12V
POWER INPUT
1 2 3
BASS SUB
BOOST PHASE LP SONIC
BP
0dB 12dB
O° 180° 35Hz 250Hz 15Hz 55kHz
SPEAKER
FUSE
4
LINE OUT LINE IN
R R
L L
OUTPUT
) and the same size like the
2
). Hereby the amplifier turns on or off with your
2
17