Helpful Hints - Sanyo CE42LM4WPR-E Bedienungsanleitung

GB
Common specification
Power source
Television system
Colour system
Channel coverage
Aerial input impedance
AV terminal
AV1: CENELEC Standard
Input: Composite video, RGB and audio-L/R
Output: TV-output with composite video and audio-L/R
AV2: BNC
Input: RGB, H and V / Y, Pb, Pr audio-L/R
Output: RGB, H and V / Y, Pb, Pr
AV3: BNC
Input: Composite video
Output: Composite video
Audio M.Out: CINCH L/R
HDMI Input :
PC Input
Serial port: RS232C: Input / Output
Contrast Ratio
Screen(inches/ cm)
(viewing measured
diagonally)
Display Resolution
Viewing angles
Dimensions (WxHxDmm) 1050 x 654 x162
Weight (kg)
12
Downloaded from www.Manualslib.com
SPECIFICA TIONS / HELPFUL
SPECIFICA TIONS / HELPFUL
Specification
220~240V 50Hz
System I B/G, D/K, L'L
PAL (PAL/NTSC3.58 in AV mode),SECAM
UHF: 21-69,
VHF: E2-E12,F2-F10,R1-R12
CATV: X, Y, S1 -S41, B-Q
75 ohm
HDMI GROUP Standard
CE42LM4WPR-E
800:1
42" / 107 cm
1366 X 768 (WXGA)
H:178°, V:178°
39.5
manuals search engine
HINTS / HOTEL MODE
HINTS / HOTEL MODE

Helpful hints

■ NO PICTURE,
● Check if monitor is plugged in.
● Try a different channel, if OK, probably station trouble.
■ POOR PICTURE
● Adjust BRIGHTNESS control.
● Adjust FINE TUNING control.
● Check aerial connections.
■ NO COLOUR, PICTURE OK
● Adjust COLOUR control.
● Adjust FINE TUNING control.
● Is the programme in colour ?
■ WEAK PICTURE
● Check aerial connections on back of set.
● Check aerial for broken wires.
● Re-orient aerial.
The following faults are not caused by the receiver:
"GHOSTS"
Reflections of signals from mountains or high buildings will cause
multiple images, called "Ghosts". These abnormal conditions can be
reduced to minimum by repositioning aerial or by installing new one
suited for your area.
"INTERFERENCE"
Interference may be caused by electrical appliances, car ignition
systems, etc. This should normally be a temporary condition, but
should this interference persist, contact your dealer.
Specification
This LCD monitor set allows you to set up the following:-
■ Prohibition of presetting.
This prohibits the use of tuning.
■ Programme position at Start up
SETTING PROCEDURE
1 . Press and hold the green button on the remote control
handset for 5 seconds.
2. Use the 5 or 6 button to highlight Hotel Mode, use the 1
to switch ON or OFF.
Hotel
Hotel mode ON / OFF
On program OFF/ 1~99
Preset ON / OFF
Address 007
Baud Rate 19200
: Select : Adjust
Select ON program using the 6 button, select the start up
3.
position using the 1 or 2 buttons.
(AV2 - AV1 - 0 - 1 - 2 - 3 - 4 ........99)
4. Press the MENU button to exit from the menu.
GB
/ AV1-AV3 /RGB/ HDMI/ PC
: Exit
MENU