Safety And Environment; Safety; Envionment; Description - AKG WMS4000 Bedienungsanleitung

1. Do not expose the equipment to direct sunlight, excessive dust, moisture, rain, mechanical vibrations,
or shock.
1. Be sure to dispose of used batteries as required by local waste disposal rules. Never throw batteries
into a fire (risk of explosion) or garbage bin.
2. When scrapping the equipment, remove the batteries, separate the case, circuit boards, and cables,
and dispose of all components in accordance with local waste disposal rules.
Dear Customer:
Thank you for purchasing an AKG product. This Manual contains important instructions for setting up and
operating your equipment. Please take a few minutes to read the instructions below carefully before
operating the equipment. Please keep the Manual for future reference. Have fun and impress your audience!
Check that the package contains all the parts listed above. If anything is missing, please contact your
AKG dealer.
You can use the PT 4000 bodypack transmitter with both dynamic microphones and condenser micro-
phones operating on a supply voltage of approx. 6 volts. You may also connect an electric guitar, elec-
tric bass, or remote keyboard.
The PT 4000 operates in one subband up to 30 MHz wide within the 650 MHz to 862 MHz UHF carrier
frequency band. Within the subband, you can either set the carrier frequency directly in 25-kHz incre-
ments or select one of the Subchannels of the Preset Frequency Groups of your transmitter.
The transmitter provides three operating modes:
In LOCK mode, the microphone output signal is transmitted to the receiver. All setup functions and con-
trols except for the MUTE switch are electronically locked to prevent parameters from being readjusted
unintentionally during a performance or lecture. The LCD screen displays the "LOCK" label.
SETUP mode allows you to adjust and save the carrier frequency and input gain.
In SILENT mode, power to the transmitter is on, but no RF signal is transmitted. We recommend using
only this mode for setting the carrier frequency. This is the only way to make sure you won't "go on air"
on a frequency that is not allocated or coordinated and risk "jamming" some other radio service or active
radio mic.
The backlit LCD screen indicates all important parameters, the current battery capacity, and the remain-
ing time before the battery will be dead.
The transmitter can be powered from two standard AA size dry batteries or the optional BP 4000 battery
pack from AKG.
Never use standard rechargeable batteries! These may damage the transmitter if the charging
contacts are shorted and will provide no remaining battery life indication. AKG will accept no lia-
bility for any damage resulting from the use of standard rechargeable batteries.
Downloaded from www.Manualslib.com
1 PT 4000 bodypack 2 x 1.5 V AA size
transmitter batteries
• BP 4000: 3 V • CH 4000:
rechargeable
battery pack
• CU 4000: • CB 40:
Charger for two
transmitters or
BP 4000 battery
packs
manuals search engine

1 Safety and Environment

1 Color Coding Kit
• Remote Mute
Carrying case Switch
(available
for one com-
soon)
plete WMS
4000 system
Neoprene bag
for
PT 4000

1.1 Safety

1.2 Environment

2 Description

2.1 Introduction

2.2 Unpacking

2.3 Optional Accessories

2.4 Description
Important!
15