Garmin ATEMOS 100 Schnellstartanleitung Seite 7

performance and higher radiated power.
You must not use the device with a third
party antenna or an antenna not approved
by Garmin . Go to www.garmin.com
®
/tracking-legal for details about the
performance and radio frequency of this
product, lawful accessories, and power
limits for countries.
Adding a Dog to the Atemos 100
Handheld Using Wireless Pairing
1
If the dog collar device is on, turn off
the dog collar device (page 4).
2
Hold until the dog collar device
emits two series of beeps (about 2
seconds), and then release .
The status LED flashes rapidly in
green. The dog collar device is now
ready to be linked, or paired, with a
handheld device.
3
On the handheld device, select Dog
List > Add Dog.
4
Bring the dog collar device near the
handheld device, and select Yes.
5
After successfully adding the dog
collar device, enter the name of the
dog, and select > OK.
6
Adding a Dog Using the Track and
Control Codes
NOTE: This feature varies based on dog
collar device type and feature availability
in your area.
Before you can add a dog using the track
and control codes, the dog owner must
find the track and control codes
(page 7) and tell them to you.
You can use track and control codes to
authorize a handheld device to interact
with your dog collar device. If you are not
near the dog you want to add or you
cannot put the collar into pairing mode,
you can add the dog using the track and
control codes.
1
Select Add Dog.
2
When asked if you are near the collar,
select No.
3
When asked if you know the track and
control codes, select Yes.
4
Enter the track or control code for the
collar, and select
The dog's track code allows you to
track the dog. The dog's control code
allows you to both track and train
(correct) the dog.
.
Quick Start Manual