Proper Use; Before Starting The Equipment; Technical Data - EINHELL TE-CG 18 Li Originalbetriebsanleitung

•
Cordless Hot Glue Gun
•
Original operating instructions
•
Safety instructions

3. Proper use

You can use the cordless hot glue gun to glue the
following materials: Wood, plastics, textiles, card-
board, ceramics, leather, etc.
The equipment is to be used only for its prescri-
bed purpose. Any other use is deemed to be a
case of misuse. The user / operator and not the
manufacturer will be liable for any damage or inju-
ries of any kind caused as a result of this.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Technical data

Power supply: ......................................... 18 V DC
Heating time: ................................. approx. 120 s
Melting temperature: ................................ 170°C
Glue stick diameter: ................................. 11 mm
Weight: .....................................................0.25 kg
Caution!
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
Anl_TE_CG_18_Li_Solo_SPK9.indb 16 Anl_TE_CG_18_Li_Solo_SPK9.indb 16
GB

5. Before starting the equipment

Danger!
Charge the equipment only with the charger sup-
plied.
Only place the equipment on non-fl ammable
surfaces.
5.1 Charging the Li battery pack (Fig. 2-3)
1. Remove the battery pack (5) from the handle,
pressing the pushlock button (6) downwards
to do so.
2. Check that your mains voltage is the same as
that marked on the rating plate of the battery
charger. Insert the power plug of the charger
(7) into the socket outlet. The green LED will
then begin to fl ash.
3. Push the battery pack onto the battery char-
ger.
In section 10 (Charger indicator) you will fi nd a
table with an explanation of the LED indicator on
the charger.
If the battery pack fails to charge, check for the
following:
•
voltage at the power socket
•
whether there is good contact at the charging
contacts of the charging unit
If the battery pack still fails to charge, send
•
the charger and charging adapter
•
and the battery pack
to our customer service center.
5.2 Inserting the glue stick (Fig. 4)
Push the glue stick (a) into the opening (b) as far
as the stop.
Important!
To avoid causing damage to the inside of the
equipment, do not pull the glue stick out of the
equipment again after it has has melted.
5.3 Changing the nozzles (Fig. 5)
To be able to work more eff ectively in certain po-
sition, you can change the nozzles (3). Proceed
as follows:
•
Pull the rubber cap (c) off the nozzle (3)
•
Remove the nozzle using a 13 mm hex key
•
Check the seal (rubber ring) on the new nozz-
le for damage
•
Fit the new nozzle to the equipment and tigh-
ten it
- 16 -
03.05.2019 10:28:01 03.05.2019 10:28:01