Beamz PLS15 Strobe Bedienungsanleitung Seite 5

IR CONTROL
The IR remote gives you control of various functions (See below). To control the fixture, you must aim the remote at the front of
the fixture and be no more than 30 feet away.
Note: When operate with IR, set menu to d001 always.
POWER - Pressing this button will power on blackout the fixture.
FULL ON - Press this button to fully light up the unit.
FADE/GOBO - No function
"DIMMER +" and "DIMMER -"-Use these buttons to adjust the output intensity
(25%~50%~75%~100%).
STROBE - This button will activate the strobe effect. You can control the flash rate by pressing
the "strobe" buttons by different times. Press this button ONE time to flash at highest rate. Press
this button a SECOND time to flash at medium rate. Press a THIRD time to flash at lowest rate.
Press a FOURTH time to exit this mode. If you press and hold this button the unit will begin to
strobe.
COLOR – No function
1-9 - No function
SOUND ON & OFF - These buttons activate and deactivate the sound active mode.
SHOW - No function
FIXTURE CLEANING
The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to optimize light output.
Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or particularly dirty surrounding
can cause greater accumulation of dirt on the unit's optics.
•
Make sure the area below the installation place is free from unwanted persons during servicing
•
Housings, fixations and installations spots( ceiling, truss, suspensions) should be totally free from any deformation
•
The mains cables must be in impeccable condition and should be replaced immediately when even a small problem is
detected
•
In order to protect the fixture from overheat the cooling fans (if any) and ventilation openings should be cleaned
monthly.
•
The interior of the fixture should be cleaned annually using a vacuum cleaner or air-jet.
•
Clean with soft cloth using normal glass cleaning fluid.
•
Always dry the parts carefully.
•
Clean the external optics at least every month. Clean the internal optics at least every 30/60 days.
ATTENTION: We strongly recommend internal cleaning to be carried out by qualified worker!
5