cecotec Cumbia POWER ESPRESSO 2.0 Bedienungsanleitung Seite 40

ENGLISH
shape of the water outlet. Turn it counter clockwise until the handle is aligned with the "lock"
mark on the appliance. Make sure the steam extraction knob is off.
Pour out hot water in the cup and place the hot cup on the removable grid.
Once the indicator light stops blinking, press the coffee button and coffee will start flowing
into the cup. Press the button again to stop brewing coffee once you have the desired amount
of drink.
Warning: Do not leave the coffee maker unattended while in use, as you need to stop it
manually.
When coffee is ready, remove the portafilter by turning it clockwise. Throw away the
coffee rests by pressing the filter with the filter fastener and turning it upside down over an
appropriate container.
Let all parts cool down and rinse them with water.
How to froth milk
Prepare an espresso as indicated in the previous section; make sure that the steam extraction
knob is off.
Press the steam button and wait until the light indicator stops blinking.
Fill a jug with about 100 ml of milk for each cappuccino you want to prepare. It is recommended
to use cold whole milk for optimal results.
Note: Use a jug with a diameter greater than 70±5 mm, and bear in mind milk doubles its
volume during this process, make sure the jug is high enough.
Turn the steam extraction knob slowly counterclockwise. Steam will come out from the steam
exit.
Note: Do not turn the steam knob quickly, as a great amount of steam could accumulate in a
short period of time and could be dangerous.
Insert about two centimetres of the steam tube into the milk. Froth milk by moving the jug up
and down.
When finished, turn the steam knob to the off position and press the steam button again to
deactivate the function.
Warning: Clean the steam exit with a wet sponge immediately after use. Then, remove the
steam tube and clean the duct's inside part. It is also recommended to emit steam again in
order to clean possible milk remaining inside the tube.
Pour frothed milk into the espresso to prepare cappuccino.
Note: It is recommended to allow the appliance to cool down for at least 5 minutes before
brewing coffee again. Otherwise, your espresso might have a light burnt odour.
How to prepare hot water
Press the coffee button and make sure the steam knob is off. The indicator light will stop
blinking once the appliance reaches the desired temperature.
Turn the steam extraction knob counterclockwise (at least 135º). Then, press the coffee button.
Hot water will flow out from the steam exit.
40
01503_Cumbia Power Expresso 20 _Manual_YV_02020218.indd 40 01503_Cumbia Power Expresso 20 _Manual_YV_02020218.indd 40 18/2/20 15:56 18/2/20 15:56