tousek RS 868 Anschluss Und Installationsanleitung Seite 9

Examples of nested commands
description
A
The brightness sensor turns on the LED with the
preset brightness (DIP 2+3) in the dark. By giving
the command „Timer on" during darkness, the
LED will light with 100% for the preset time (POT).
When the time runs out, the brightness of the LED
changes back to the preset brightness.
B
The brightness sensor turns on the LED with the
preset brightness (DIP 2+3) in the dark.
AUS-Befehle bewirken 100% bzw. 0% Leuchtstär-
ke, die bis zu Beginn der nächsten Dunkelperiode
aktiv bleibt. Erst dann schaltet der Helligkeitssensor
die LED wieder auf die voreingestellte Leuchtstärke.
Auch beim Überschreiten der Helligkeitsschwelle
wird die LED nicht durch den Helligkeitssensor,
sondern erst mit dem „AUS"-Befehl des Hand-
senders ausgeschaltet.
C
If a new command is given during the operating
mode, then only the last command is valid.
E.g. After the command „Timer on" the command
„OFF" is given, then the second command has
priority: The LED turns off.
Deleting transmitter channels
FUNCTION deleting process
1x
Deleting individual
channels
Deleting all stored
channels
tousek / EN_RS868-LED-SYSTEM_01 / 23. 01. 2020
B1
EIN- bzw.
B2
P2
ST LED
2x
P2
ST LED
~10sec.
e.g. 25%
(DIP 2+3)
100%
e.g. 25%
(DIP 2+3)
100%
< 1s
e.g. 25%
(DIP 2+3)
100%
< 1s
100%
description
Keep the delete button P2 pressed. As soon as the
buzzer emits slow successive tones, press the trans-
mitter channel additionally which you wish to delete.
When the deleting procedure is fnished, the buzzer
emits a continous tone.
For deleting additional transmitter channels, please
repeat the whole procedure.
Press the delete button P2 2x and keep the button
pressed. The buzzer emits fast successive tones
for approx. 10s.
When the deleting procedure is fnished, the buzzer
emits a continous tone.
25%
TIMER (POT)
< 1s
< 1s
TIMER (POT)
25%
25%
- 9 -