Troubleshooting Table; Scrapping The Machine - Tennant S7 Bedienungsanleitung

REPLACING AND ADJUSTING THE CABLES
Replacing the drive cable
To replace the drive cable, proceed as follows:
• Remove the top cowling from the machine.
• Loosen the dowel on the cable locking pin.
• Pull the cable out of the locking pin and completely out of the
drive handle.
To reassemble the cable:
• Insert one end of the cable into the adjustment screw on the
drive handle (the end without the spherical cable lock).
• Insert the cable into the sheath.
• Attach the spherical cable lock to the handle.
•
and then through the cable locking pin.
• Tighten the locking dowel.
To adjust the cable, use the two registers until obtaining the
desired position.
Replacing the side brush lifting cable
To replace the side brush lifting cable, proceed as follows:
• Remove the top cowling from the machine and the front bin.
• Remove the front bumper, the right-side wheel and the right-
side cover.
• Loosen the cable clamp.
•
• Remove the handle from the support and open it.
• Remove the cable from the two sheaths.
To reassemble the cable:
• Place the cable in the handle.
•
• Insert the cables into the sheaths.
• Lock one end of the cable with the clamp and the other end
To adjust the cable, use the two registers until obtaining the
desired position.
EN

TROUBLESHOOTING TABLE

FAULT
The centre brush
The side brushes
do not rotate.
hold its charge
Dust comes out
of fan
The brushes wear
out too quickly
Dust released
when working
The suction motor
The machine
In the event of other malfunctions, contact the
NOTES
dealer

SCRAPPING THE MACHINE

If the machine is to be scrapped, please note that the batter-
ies CANNOT be considered ordinary waste, rather they must
be disposed of in accordance with the laws in force. As the
mended to disassemble it and sort the parts into groups of
the same material, in accordance with the laws in force.
DO NOT USE ANY PART BEING SCRAPPED AS A SPARE
PART. IN THIS CASE TOO, KEEP ALL PARTS OUT OF THE
REACH OF CHILDREN.
- 11 -
TRANSLATION OF ORIGINAL INSTRUCTIONS
CAUSE SOLUTION
Belt broken Replace
Gear motor Contact service
damaged centre
Contact service
Wire detached centre
Belt broken Replace
No liquid (for lead-
Top up
acid battery)
Loose terminal Tighten.
Replace
Filter positioned
Reposition
incorrectly
Worn gaskets Replace
Brushes pressed
Adjust
too hard
Replace
Filter clogged Clean
Contact service
Motor burned out
centre
Contact service
Wire detached centre
Battery terminals
Check
detached
Batteries
Recharge
discharged
-