Remove The Brush Cutter; Transportation And Storage; Store The Machine; Troubleshooting - GreenWorks GST1246 Bedienungshandbuch

WARNING
Wear gloves and be careful with sharp edges.
WARNING
Apply the guard to the blade.
WARNING
Use the specified Nylon locknut which is packed with the
blade, to assemble the blade.
WARNING
You must change the locknut after you use it for 20 times.
1. Put the metal rod in the specified angle transmission hole
to fix the trimmer head.
2. Put the inner cup onto the center shaft.
3. Put the brush-cutter blade on top of the inner cup.Make
sure the blade is in the center.
4. Put the plate above the blade.
5. Put the outer cup above the plate.
6. Put the locknut above the outer cup.
7. Tighten the lock-nut counter-clockwise to 44-58" N.M of
torque with a 19mm wrench.
5.8

REMOVE THE BRUSH CUTTER

Figure 3.
WARNING
Apply the guard to the blade.
1. Put the meatal rod in the specified angle transmission
hole to fix the trimmer head.
2. Loosen the nut clockwise and remove the outer cup.
3. Remove the plate and brush-cutter blade.
4. Remove the inner cup.
6 TRANSPORTATION AND
STORAGE
WARNING
Remove the battery pack from the machine before
tranportation and storage.
6.1

STORE THE MACHINE

• Remove the battery pack from the machine.
• Make sure that children cannot come near the machine.
• Keep the machine away from corrosive agents such as
garden chemicals and de-icing salts.
English
• Secure the machine during transportion to prevent
damage or injury. Clean and examine the machine for any
damage.
7

TROUBLESHOOTING

Problem Possible Cause
The ma- No electrical con-
chine does tact between the
not start machine and the
when you battery pack.
push the
trigger.
The battery pack is
depleted.
The lock-out but-
ton and trigger are
not pushed at the
same time.
7
Solution
1. Remove battery pack.
2. Check contact and in-
stall the battery pack
again.
Charge the battery pack.
1. Pull the lock-out but-
ton and hold it.
2. Pull the trigger to start
the machine.
EN