Musway D8v2 Bedienungsanleitung Seite 17

Malfunction: amplifier runs into protection mode
Reason:
1. Short circuit on the loudspeakers or cables
2. Overheated by too low speaker impedance
3. Insufficient air circulation by a inappropriate mounting position of the amplifier
4. Overloaded by insufficient power supply (too small profile section on the power cables)
Malfunction: hiss or white noise on the loudspeakers
Reason:
1. The level controllers in the DSP software are turned up to loud
2. The treble controller on the head unit is turned up
3. The speaker cables or the RCA audio cables are defective
4. The hissing is caused by the head unit
ENGLISH
Remedy:
Reconnect
Choose a higher impedance
Use a new speaker setup
Change the mounting position
Ensure air circulation
Use a bigger profile section
Remedy:
Turn down the level
Turn down the level on the head unit
Replacing the cables
Check the head unit
17