Checking For Leaks - Klarstein Pizzaiolo Pro Bedienungsanleitung

hose shall not exceed 1.5 m. In Finland, the length shall not exceed 1.2m. The hose
should certified according to applicable EN Standard and comply with local code.
Storage of appliance
• Indoor storage of the grill is possible if the gas cylinder is separated from the grill.
If the grill is not to be used for a longer period of time, it should be stored in its
original packaging in a dust-free environment.
Gas cylinder
The gas cylinder should not be dropped or handled roughly! If the appliance is not in
use, the cylinder must be disconnected. Replace the protective cap on the cylinder after
disconnecting the cylinder from the appliance. The gas cylinder must be sited outside the
body of the appliance.
Always connect or replace the cylinder in a well-ventilated area and away from any
source of ignition, never in the presence of a flame, spark or heat source.
Cylinders must be stored outdoors in an upright position and out of the reach of children.
The cylinder must never be stored where temperatures can reach over 50 °C. Do not
store the cylinder near flames, pilot lights or other sources of ignition. DO NOT SMOKE.
This barbecue is designed for use outdoors, away from any flammable materials. It
is important that there are no overhead obstructions and that there is a minimum
distance of 1 m from the side or rear of the appliance. It is important that the
ventilation openings of the appliance are not obstructed. The barbecue must be
used on a level, stable surface. The appliance should be protected from direct draughts
and shall be positioned or protected against direct penetration by any trickling water
(e.g. rain).
Make sure that the gas cylinder compartment (if any) is not obstructed, keep it ventilated
and clean.

CHECKING FOR LEAKS

• Make 2-3 fluid ounces of leak detecting solution by mixing one part washing up
liquid with 3 parts water.
• Ensure the control valve is "OFF".
• Connect the regulator to the cylinder and ON/OFF valve to the burner, ensure the
connections are secure then turn ON the gas.
• Brush the soapy solution onto the hose and all joints. If bubbles appear you have a
leak, which must be rectified before use.
• Retest after fixing the fault
• Turn OFF the gas at the cylinder after testing.
• If leakage is detected and cannot be rectified. Do not attempt to cure leakage but
consult your gas dealer.
EN
35