TFA 60.2542 Bedienungsanleitung Seite 13

TFA_No. 60.2542_Anleitung
Radio-controlled alarm clock
5. Elements
A: Display (Fig. 1):
A 1: Indoor temperature
A 2: Time
A 3: AM/PM
A 4: Date
A 5: Day of the week
A 6: Alarm symbol
A 7: DCF reception symbol
A 8: Daylight Saving Time symbol
A 9: Seconds
A 10: Snooze symbol
B: Buttons (Fig. 2+3):
B 1: SNOOZE/LIGHT button
B 2: ALARM ON/OFF button
B 3: MODE button
▲ button
B 4:
▼ button
B 5:
B 6: WAVE button
24
29.08.2017 13:37 Uhr Seite 13
Radio-controlled alarm clock
C: Housing (Fig. 3):
C 1: Battery compartment
6. Getting started
• Open the battery compartment and insert two new AAA 1,5
V batteries. Make sure the polarity is correct.
• Close the battery compartment again.
• The device will alert you with a beep and all segments will
be displayed for a short moment.
7. Radio-controlled time reception
• The clock will now scan the DCF frequency signal and the
DCF symbol will be flashing on the display. When the time
code is successfully received after 3-8 minutes, the radio-
controlled time, the date, the day of the week and the DCF
symbol will be shown steadily on the display.
• The DCF reception always takes place at 1:00 in the morn-
ing. If the reception is not successfully received, further
attempts will be taken at 2:00, 3:00, 4:00 and 5:00 o'clock.
• You can also start the initialization manually.
25