Brush Replacement; Power Cord Replacement; Possible Cause; Service / Trouble Shooting - Triton MOF001 Gebrauchs- Und Sicherheitsanweisung

Dual mode precision plunge router

Vorschau ausblenden Andere Handbücher für MOF001:

Gebrauchs- und sicherheitsanweisung (83 Seiten)

Bedienungs- & sicherheitsanweisung (81 Seiten)

Gebrauchs- und sicherheitsanweisung (62 Seiten)

Inhalt

Inhaltsverzeichnis

Verfügbare Sprachen

SERVICE

• Any damage to the router should be repaired and

carefully inspected by qualified repair personnel before

use. Service or maintenance performed by unqualified

personnel could result in injury.

• Servicing should only be carried out by authorised

Triton Repair Centres using original Triton replacement

parts. Follow instructions carefully and refer to

'Troubleshooting' for problem identification and advice.

Use of unauthorised or faulty parts may create a risk of

electric shock or injury.

• Triton Precision Tools will not be responsible for any

damage or injury caused by unauthorised repair of the

router or by mishandling of the tool.

BRUSH REPLACEMENT

The carbon brushes are a consumable item which should

be inspected periodically and replaced when worn. Failure

to do so may result in damage to the motor.

TROUBLESHOOTING

The following chart contains information designed to assist in diagnosing and resolving router problems.

SYMPTOM

Router will not operate

Router runs slowly

Makes an unusual sound

Excessive vibration

Heavy sparking occurs inside

motor housing

Service / Trouble Shooting

POSSIBLE CAUSE

• No power supply

• Brushes worn or sticking

• Switch is faulty

• Motor components open or short

circuited

• Blunt or damaged cutter

• Variable speed set low

• Motor is overloaded

• Mechanical obstruction

• Armature has shorted sections

• End of adjustment range is

reached

• Plunge lock lever incorrectly

positioned

• Armature short circuited or open

circuited

• Commutator dirty

1. With the router disconnected from power, unscrew

the Brush Caps (3) located on the front and rear of the

motor.

2. Remove the brushes by pulling carefully on the

protruding springs.

3. If either of the brushes is

worn to less than 6mm

long, they must both be

replaced using genuine

Triton replacement brushes

- available from Authorised

Triton Repair Centres.

POWER CORD REPLACEMENT

If the supply cord needs replacing, the

task must be carried out by the manufacturer, the

manufacturer's agent,

or an authorised service centre in order

to avoid a safety hazard.

REMEDY

• Check power is available at source

• Disconnect power, open brush caps and

ensure brushes move freely in the holders.

Check whether the brushes require

replacing – see 'Brush Replacement'

(above)