Adjusting The Level Of The Appliance; Water Connection; Inlet Hose - AEG Electrolux Favorit 52850 Benutzerinformation

40

Water connection

Make sure that the dimensions of the recess agree with the given dimensions.
Make sure that there are openings in the furniture for the inlet hose, the water drain hose
and the mains cable.

Adjusting the level of the appliance

Make sure that the appliance is level to close and seal the door correctly. If the level of the
appliance is correct, the door does not catch on the sides of the cabinet. If the door does
not close correctly, loosen or tighten the adjustable feet until the appliance is level.
Water connection

Inlet hose

The appliance has safety features to prevent that the water in the appliance goes back into
the drinking water system.
Connected the appliance to a hot (max. 60°) or cold water supply.
If the hot water comes from alternative sources of energy that are more environmentally
friendly (e.g. solar or photovoltaic panels and aeolian), use a hot water supply to decrease
energy consumption.
It is important that a water tap or stopcock is near the dishwasher with easy access.
Connect the inlet hose to a water tap with an external thread of 3/4".
If the water inlet hose is too short, replace the water inlet hose with
an applicable, longer high-pressure hose. Do not connect an exten-
sion hose.
To suit the installation, it is possible to turn the end of the hose that
is connected to the dishwasher. Do these steps :
1. Loosen the retaining nut.
2. Turn the hose.
3. Tighten the retaining nut.