Battery Installation; English - Kenwood AT850 Bedienungsanleitung

key
rubber mat
weighing platform
'unit' touch pad to select
weighing units
display
'on/zero' touch pad
clip for removing battery cover
battery compartment

battery installation

1 Unclip the battery cover on the
underside of the scale by pushing
the clip inwards and then lifting off.
Remove the plastic film between the
battery and its connector by pulling
on the red tab
unit to function.
Note - During use, if the battery
symbol ' ' appears in the display,
it means that battery power is low
and the batteries should be replaced
(see service).
to weigh
Always place the scale on a dry and
flat surface prior to weighing.
A rubber mat is supplied and can be
fitted to the surface of the scale. This
will help to prevent scratching of the
weighing platform and will also
create a non slip surface for the
weighing container. It is ideally suited
for Kenwood mixing bowls.
Press the 'on/zero' touch pad to
switch on. When the display shows
'0', place the item to be weighed
onto the platform. The weight will
appear on the display.
Note:-
G
The scale will read '
trying to weigh above its capacity.
to select weighing units
After switching on the scale, press
the 'unit' touch pad. Each time the
touch pad is pressed the weighing
unit displayed will alternate between
g and lb oz.
, this will allow the
' if it is
to add and weigh
After the weight is displayed, press
the 'on/zero' touch pad once and
the display will flash twice and then
return to '0'. Add the next ingredient
and the weight of that ingredient will
be displayed. This can be repeated
until all the ingredients are weighed.
G
When removing an item from the
scale during add and weigh, a '-' will
appear in the display to represent a
minus reading.
Note:-
G
The maximum weighing capacity is
8 Kg/17 lb 9 oz. This is the total
weight of all ingredients plus the
weight of the container.
auto switch off:
Automatic switch off will occur if the
scale shows the same weight
reading for 3 minutes.
manual switch off:
To conserve the battery power,
switch off the scale when not in use.
To do this, press and hold the
'on/zero' touch pad until the display
disappears.
cleaning
Do not immerse the scale in water.
Wipe over the scale and rubber mat
with a damp cloth, then dry
thoroughly. Do not use abrasive or
chemical agents to clean.
Alternatively the rubber mat can be
washed by hand and then dried.
important
G
The scale is for domestic use only.
G
Always ensure the weighing platform
is thoroughly clean before placing
items directly on its surface. Do not
place food directly on the surface of
the rubber mat.
G
When weighing do not place items
on the edge of the weighing
platform, always place them in the
centre.
2