Maintenance - Rexel Autofeed AUTO+ 200X Erste Schritte

GB
lubrication of the shredder
Only use Rexel Oil Sheets (2101948 & 2101949) to lubricate. ACCO Brands Europe accepts no
liability for product performance or safety when other types or brands of lubricants are used on any
part(s) of this machine. Rexel recommend using an oil sheet after the bin has been emptied three
times (and for on-going three bin cycle thereafter). Insert the oil sheet into the manual feed slot and
NOT in the auto-feed chamber. Using an oil sheet in the auto-feed chamber will contaminate the
feed rollers preventing the auto-feed mechanism shredding. Follow the maintenance instructions if
the rollers become contaminated.

7. maintenance

The rollers on the auto-feed mechanism may become dirty over time, please wipe clean with a dry
cloth to maintain maximum product performance.
The auto-start infra-red sensor, located in the paper feed entry-slot, can occasionally become
covered in paper-dust causing the shredder to run despite no paper being fed into the machine.
Switch the shredder off at the rear of the machine and carefully clean the sensor using a cotton-
swab.
service
We recommend these machines are serviced every 6 to 12 months by a Rexel service engineer –
see back of this booklet for the contact details of your local service centre and for enquiries about
maintenance contracts.
shredder accessories
We recommend that a paper waste sack for
recycling shredded paper is used on all models.
12
register this product online at www.accobrands.com
Accessory Part Number
Recycling Waste 1765031EU
Sack
Plastic Waste 40060
Sack
Oil Sheets 2101949
2101948
Box Quantity
20
100
20
12