Factory Defaults - Cameo LED MOVING HEAD 60 W Bedienungsanleitung

oPeRaTion:
SeLeCTing dmX mode
Use this function to activate either the 8-channel or 13-channel DMX mode.
Press the MODE button ("Addr" will appear in the display) and then use the
UP and DOWN buttons to select the DMX mode selection function ("CHMO"
will appear in the display). Now press the ENTER button and use the UP button
to select the 8-channel mode (08CH) or DOWN to select the 13-channel mode
(13CH) and confirm with ENTER.
FiXTURe Time
Use this function to display the number of hours for which the unit has been
in operation.
Press the MODE button and then use the UP and DOWN buttons to select
the Fixture Time function ("F I t I" will appear in the display). Now press the
ENTER button. The display now shows the number of hours for which the
unit has already been in operation.
ReSeT
Use this function to start the motor reset process.
Press the MODE button and then use the UP and DOWN buttons to select
the Reset function ("r E S t" will appear in the display). Now press the
ENTER button. The reset process will begin and after approx. 20 seconds,
the motors are realigned and the unit is operational.

FaCToRY deFaULTS

You can use this function to reset the unit to the factory default settings.
Press the MODE button and then use the UP and DOWN buttons to select
"LOAd". Now press the ENTER button. All settings (microphone sensitivity,
reverse display...) have now been reset to the factory defaults. The unit is
immediately operational again.
noTe
If one of the 4 buttons is not pushed, the LED display switches off automati-
cally after approx. 70 seconds. As soon as one of the four buttons is pressed,
the display switches on again automatically. In DMX mode, the display blinks
as soon as the light no longer receives a DMX signal.
11