Operation; Error Messages; Technical Data; Warranty - ADE KE 1506 Farina Bedienungsanleitung

Thank you for purchasing a high-quality WAAGEN-SCHMITT product. Your new scales
feature tried-and-tested quality and meet the highest technical standards.
Please read these Operating Instructions carefully before using the product for the first
time, and keep them in a safe place so that you can consult them again if you need
further information.
1.
Start-up
Inserting the batteries:
Open the lid of the battery compartment on the underside of the scales and insert the
batteries supplied (4 x 1.5V AA). Please ensure the correct polarity of the batteries (+/-).
Safety guideline s:
Ensure that no objects fall onto the scales; otherwise, the scales
may be damaged.
Use only a damp cloth to clean the scales. Never use solvents or
abrasive cleaning agents. Do not immerse in water. If the scale's
plastic parts come into contact with grease, spices, vinegar or
any other strongly spiced or coloured foods, please ensure you
clean them immediately. Keep citric acid away from the scales.

2. Operation

Switch ing on the scales:
Place the scales on a firm, level surface. Press down on the scales' surface for about
2 seconds with a pressure of 500 g to switch the scales on. The backlighting lights up,
the display shows initially "HI", and once stabilized, will switch to "0 g" or "0.0 oz"
depending on setting. The scales are now ready for use.
Note: If, after activating the scales, a weight-value is displayed, touch the TARE button
to set the scales to zero.
Units of weight:
By touching the g/lb button you can change the country-specific unit of weight (g =
gram / oz = ounce). Please make sure that the scales are set to the weight-unit relevant
to you.
Tare weight function:
Touching the TARE button will set the scales to "0 g". Place e.g. a bowl on the scales,
and touch the TARE button to set the scales back to "0 g". You can repeat this
procedure as often as you like until you reach the scales' max. load capacity (5 kg) is
reached. Once you remove your weighed item(s), the total weight is shown as a minus
value.
2
Automatic deactivation:
The backlighting of the scales switches off automatically if no weight change is registered
for about 10 seconds. The scales will switch off automatically if no weight change is
registered for about 1 minute.

3. Error messages

"Lo" = Battery is empty – Please replace the batteries with the appropriate
battery type (4 x 1.5V AA).
" OUEΓ" = Overload – The 5 kg maximum load capacity has been exceeded.
Remove the object from the scales immediately to avoid damaging the
scales' load cell unit.

4. Technical data

Load capacity x gradation: Max. 5 kg x 1 g
Dimensions: 200 mm x 210 mm x 17 mm
Batteries: 4 x 1.5V AA (included)
Subject to technical changes as a result of product improvements.

5. Warranty

WAAGEN-SCHMITT guarantees the free correction of defects resulting from material or
manufacturing faults through repair or exchange 3 years from the purchase date. Please
get your warranty section filled out and stamped by the retailer when you make your
purchase. In case of warranty, return the scales to your retailer along with the warranty
section indicating the reason for your complaint.
Note: Extreme sources of electromagnetic radiation, such as those caused by the
operation of radio equipment in the vicinity of the scales, can affect the value displayed.
Once the interference has been eliminated, the product will once again function normally.
Note: the unit may need to be reset.
Le gal information obligation regarding the disposal of batteries:
Do not dispose of batteries in domestic waste. As a consumer, you are legally required to
return used batteries. You may return your used batteries to public collection points in
your community or to any retailer that sells batteries of the same type.
Note:
The following symbols are used on batteries:
Li = Battery contains lithium
Al = Battery contains alkaline
Mn = Battery contains manganese
CR (Li); AA (Al, Mn); AAA (Al, Mn)
3