Anleitung_P_AS_3_6_Li_4513416:_
7. Before starting the equipment
Caution:
Be sure to read the following information before
you use your cordless screwdriver for the first
time:
1. Only charge the battery pack using the
charger supplied.
2. Only use screwdriver bits which are in
perfect working order and appropriate.
3. When screwing into walls or partitions, test
these for electrical, gas or water
connections.
8. Operation
8.1 Charging the battery pack (Fig. 1)
The battery pack is protected from exhaustive
discharge. An integrated protective circuit
automatically switches off the equipment when
the battery pack is flat. In this case the bit chuck
(1) will cease to turn.
Caution:
Do not press the ON/OFF switch (9) any more,
if the protective circuit has actuated. This may
damage the battery pack.
1. Check that your mains voltage is the same
as the voltage indicated on the rating plate
of the battery charger. Plug the battery
charger (11) in the plug socket and connect
the charging cable (12) to the charging
connection (8). The charging process starts
as soon as the charging cable is connected
to the charging adapter.
2. The charging control lamp (7) indicates that
the battery is being charged.
3. The charging control lamp (7) goes out
when charging is completed.
Caution:
The handle may become a little warm during
the charging process. This is
normal.
16.04.2009
8:23 Uhr
Seite 11
If the battery pack fails to charge, please check
whether there is voltage at the socket-outlet.
whether there is good contact at the
charging contacts of the battery charger
(11).
If the battery still fails to charge, send
the battery charger (11)
and the screwdriver
to our customer services department.
Timely recharging of the battery pack will help
to prolong its lifespan. You must recharge the
battery pack when you notice that the power of
the screwdriver drops.
8.2 Clockwise/Counter-clockwise selector
switch (Fig.2/Item 10)
The slide switch (10) above the ON/OFF switch
(9) is for setting the direction of rotation of the
cordless screwdriver and for preventing the
cordless screwdriver from being switched on
inadvertently. You can select between
clockwise and counter-clockwise rotation.
Caution:
Change the direction of rotation only when the
equipment is at a standstill. If you fail to observe
this point, the gearing may become damaged.
When the slide switch (10) is in the middle
position, the ON/OFF switch (9) is blocked.
Direction
Clockwise
Counter-clockwise
8.3 ON/OFF switch (Fig. 2 / Item. 9)
Press the On/Off switch to switch the cordless
screwdriver on. Release the ON/OFF switch to
switch off.
8.4 LED lamp (Fig. 1/Item 2)
The LED lamp (2) can be used in poor lighting
conditions to illuminate the area where you
want to screw. To switch ON, press the switch
(4) and to switch OFF, press the switch (4)
again.
GB
Switch position
"F" pressed
"R" pressed
11