End-Of-Charging; Display Indication - Beta 1498/4A Gebrauchsanweisung

INSTRUCTIONS FOR USE
MOD. 4A
OPERATING THE BATTERY CHARGER
1. Once the output leads have been connected to the battery, plug the power supply lead of the battery charger into the mains,
making sure the voltage matches the rated voltage of the battery charger;
2. With the battery charger in "stand-by" mode and the ON LED lighting up, set the charging parameters suitable for the type of
battery to charge using the key on the control panel. The charging process will start automatically.
Charging parameters that can be set:
Charge for 12V batteries, 4Ah to 30Ah
Maintenance charge for 12V batteries, 4Ah to 70Ah
Suitable for charging GEL or wet batteries
Charge for 12V batteries, 30Ah to 80Ah
Maintenance charge for 12V batteries, 30Ah to 120Ah
Suitable for charging WET batteries
Charge for 12V batteries, 30Ah to 80Ah
Maintenance charge for 12V batteries, 30Ah to 120Ah
Suitable for charging AGM-START&STOP and AGM-SPIRAL or WET batteries with temperatures below 5 °C
Automatic charge selection for 6V batteries
6V
Maintenance charge for 6V batteries, 4Ah to 30Ah
Maintenance charge for 6V batteries, 4Ah to 70Ah
Charge indicators:
The battery is charging.
The battery is fully charged (100%); the battery charger will switch to the maintenance step, keeping the state of
ef ciency of the battery constantly monitored, so that it is always at an optimal level of charge.
The display will show the word FULL, which will alternate with the maintenance voltage of the battery
INTERRUPTION OF THE CHARGE CYCLE IN CASE OF MAINS BLACKOUT
In case of blackouts in the 230V mains, the battery charger saves the work cycle it was performing in order to restore it automati-
cally as soon as the power supply of the 230V mains is restored. This function is crucially important if the battery charger is used
to charge batteries without the operator supervising the cycle; for example, during very long work cycles (maintenance charges)
or when charging overnight (charges for vehicles that need to be charged daily). (The set parameters are stored for 12 hours;
after 12 hours the battery charger will resume charging with the default parameters).

END-OF-CHARGING

1. Unplug the power supply lead of the battery charger from the mains.
2. Disconnect the output lead with black clamp from either the vehicle's earthing point or the negative terminal (-) of the battery.
3. Disconnect the output lead with red clamp from the positive terminal (+) of the battery.
BATTERY TESTS AND ERROR INDICATORS
In cause of faults, the battery tester will display the following indications:

DISPLAY INDICATION

CAUSE
The clamps of the output leads are not
connected correctly to the battery.
Polarity reversal.
Battery voltage too high. (You are attempting
to charge a 24V battery).
SOLUTION
Position the clamps correctly and start
charging the battery again (see section
"Operating the battery charger").
Check the battery voltage.
EN
13