Belkin F5U508 Handbuch Seite 16

Installation
3. Remove the port cover that corresponds with the PCI slot you wish to use.
4. Insert the PCI Card into the slot. Apply pressure as needed until the Card is
5. After installing the PCI Card, replace the outer cover and turn on the
6. When Windows restarts, the PCI Card will be detected and install drivers
EN
Note: Depending on the speed of your computer, it may take up to 45 seconds
for the PCI Card to be detected.
Verifying Proper Installation for Windows 2000 with Service Pack 4
After installation, check the Device Manager to confirm that the PCI Card has
been properly installed.
1. Right-click on "My Computer".
2. Select "Properties".
3. Select the "Hardware" tab and click on the "Device Manager" button.
4. Click the plus sign (+) next to "Universal Serial Bus Controller".
12
5248ea-A_F5U508ea.indb 12
(The cover is usually held in place with a single screw).
fully seated. Secure the PCI Card with the screw removed in step 3.
computer.
for two "Ali PCI to USB Open Host Controller", one "Standard Enhanced PCI
to USB Host Controller", one "USB 2.0 Root Hub", two "Root Hub" entries,
and one "OHCI Compliant IEEE 1394 Host Controller".
14/2/07 9:08:50 am