Special Safety Instructions For This Machine; Designated Use; Supplied Parts; Unpacking The Appliance - Proficook PC-AE 1001 Bedienungsanleitung

Special Safety Instructions for
this Machine
WARNING:
• Risk of cuts! The centrifuge sieve is sharp!
• If the rotating sieve is damaged, the device
shall not be operated.
• Always use the supplied tamper. Do not insert
your fingers or tools into the filler opening.
• Do not operate the mixer for more than 1 min-
ute! Afterwards, let it cool for approximately
3 minutes before you use it again.
• Do not touch any moving parts of the machine
and always wait for it to stop.
• The machine should only be used under super-
vision!
• Do not manipulate any of the safety switches!
• Do not remove the lid during operation.
• Do not put your fingers into the filler opening.

Designated use

This appliance is intended to extract juice from fruit
and vegetables.
Do not use for too hard foodstuffs such as nuts or
chocolate.
It is intended for the use in private households and
similar applications.
It is only to be used as instructed in this user
manual. The appliance is not intended for com-
mercial use.
Any other use shall be considered as not intended
use and can lead to material damage or even
personal injury.
The manufacturer shall not be liable for damages
caused by not intended use.

Supplied parts

1 base device with motor
1 transparent cover
1 tamper
1 centrifuge sieve
1 centrifuge housing
1 pomace container

Unpacking the appliance

1. Remove the device from its packaging.
2. Remove all packaging materials like foils, filling
materials, cable holders, and carton packaging.
3. Check the scope of deliveries for completeness.

NOTE:
There may still be dust or production remains on
the device. We recommend that you clean the
device as described under "Cleaning".

Description of the Parts

1 Tamper
2 Filler opening
3 Transparent cover
4 Safety switch
5 Centrifugal sieve
6 Centrifuge casing
7 Drive wheel
8 Safety bracket
9 Control panel
10 Base device with motor
11 Pomace container

Preparations

For assembly, also refer to the illustrations on
page 3.
1. Set the device so that the switch points towards
you.
2. Tilt the safety handle to the right.
3. Attach the pulp container on the left side. In
the next step it is secured by the collar of the
centrifuge casing.
4. Attach the centrifuge casing on top of the base
casing. The base casing has a recess. Here the
spout of the centrifuge casing must be placed.
WARNING risk of cuts! The centrifugal
sieve is sharp!
5. Place the centrifugal sieve on top of the drive
wheel. Press it down. It clicks in place on the
drive wheel.
35