Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
A HARDWARE TOUR
REAR VIEW
9 DC Input
This is the power supply input for DC +5 V and +12 V.
Pin
Name
1
+12
2
G
3
G
4
+5
0 Host IDE Interface
This is a 40 pin I/O connector according to the ATA specifications.
- Device Configuration Jumper
This is the jumper switch for selection of the drive use mode and supporting PC.
Short-circuit socket is attached for the setting
attached : on
Pin
Name
1
1
MA*
on The drive is used in master mode.
2
SL
on The drive is used in slave mode.
3
CS
on Mode for drive setting by CSEL of the IDE interface.
4
5
RPC on Stay in RPC Phase I mode
SET off Start RPC Phase II mode (Never return to Phase I mode
1
2
*
*
1
*
Pin 1 (MA) and Pin 5 (RPC SET) are ON at the time of shipping from the plant.
2
*
For a DVD Video playback system (computer) for Phase I, please use with Phase I. When the DVD
Video playback system (computer) and the drive have different region codes, DVD Video playback is
not possible.
Set the jumper switch to OFF only when use of a drive corresponding to Phase II has been speci
fied clearly for the DVD Video playback system (computer). DVD-A02 will be initialized automatically
and will operate in Phase II mode.
= Audio Output
This is a connector for output of analog audio.
As a Molex 70553 type connecter is used, select a matching connection cable.
Pin
Name
1
L
2
G
3
G
4
R
8
<DRC1074>
En
4
1
5
1
=
-
Function
Power supply input for DC +12 V.
Ground.
Ground.
Power supply input for DC +5 V.
not attached : off
Reserved.
after Phase II mode is used.)
Function
Left channel audio output.
Ground.
Ground.
Right channel audio output.
39
40
0
Function
1
2
4
1
9
Fig. 2
Werbung
Inhaltsverzeichnis
