Battery Charging - LaserLiner Quadrum Bedienungsanleitung

Battery charging

– Charge the device's battery completely prior to use.
– Connect the charger to mains power supply and the charging socket (I) of
the battery compartment (K). Please only use the charger supplied; using a
different charger will invalidate the warranty. The rechargeable battery can
also be charged when it is not inserted in the device.
– When the rechargeable battery is being charged, the LED on the charger
(M) lights up red. When the LED changes to green, charging is complete.
When the unit is not connected to the charger the power charger's LED
lamp will blink.
– Alkaline batteries (4 x type C) can be used as an
alternative. Insert them in the battery compart-
ment (J) as per the installation symbols.
– Insert battery (K) / battery compartment (J) into
slot (F) and secure it in place with fastening
screw (H). The electrical contacts (G) must be
connected.
– With the rechargeable battery inserted, the
device is ready to run even during charging.
– When all 3 LEDs (2, 4, 5) light up briefly and
the device switches off, the batteries must be
replaced or the rechargeable battery charged.
Insert batteries into the remote control
– Observing the correct polarity.
–
AAA
–
AAA
+
+
Quadrum / Quadrum Green
G
F
J
– +
C
I
K
H
17
GB