3M DBI SALA M100 Bedienungsanleitung Seite 10

4.2 INSPECTION PROCEDURES: Inspect this product per the procedures listed in the "Inspection and Maintenance Log".
Documentation of each inspection should be maintained by the owner of this equipment. An inspection and maintenance
log should be placed near the product or be otherwise easily accessible to users. It is recommended that the product is
marked with the date of next or last inspection.
4.3 DEFECTS: If the Floor Mount Base cannot be returned to service because of an existing defect or unsafe condition, then
either destroy the system or contact 3M or a 3M-authorized service center about possible repair.
4.4 PRODUCT LIFE: The functional life of the Floor Mount Base is determined by work conditions and maintenance. As long
as the product passes inspection criteria, it may remain in service.
5.0 MAINTENANCE, SERVICE, and STORAGE:
5.1 CLEANING: Periodically clean the metal components of the Floor Mount Base with a soft brush, warm water, and a mild
soap solution. Ensure parts are thoroughly rinsed with clean water.
5.2 SERVICE: Only 3M or parties authorized in writing by 3M may make repairs to this equipment.
6.0 LABELS and MARKINGS:
6.1 LABELS: Figure 7 illustrates labels on the Floor Mount Base. All labels must be present on the Floor Mount Base. Labels
must be replaced if they are not fully legible. Information provided on each label is as follows:
A) Notified Body and Standard Information
1 B) Safe Working Radius
C) Read Instructions
A) Serial Number
2 B) Manufactured Year/Month
C) Model Number
10