Installation - AEG L 71470 FL Benutzerinformation

26 www.aeg.com

13. INSTALLATION

Downloaded from www.Manualslib.com
Problem Possible cause
You did not remove the
stubborn stains before
you wash the laundry.
Incorrect temperature
was set.
Too much laundry load.
After the check, activate the appliance.
The programme continues from the
point of interruption.
If the problem occurs again, contact the
service centre.
13.1 Fixing plate kit
(4055171146)
Available from your authorized dealer.
13.2 Unpacking
manuals search engine
Possible solution
Use special products to remove
the stubborn stains.
Make sure that you set the cor-
rect temperature.
Decrease the laundry load.
If the display shows other alarm codes,
contact the service centre.
If you install the appliance on a plinth,
secure the appliance in the fixing plates.
Follow the instructions supplied with the
kit.
1. Use the gloves. Remove the external
film. If necessary, use a cutter.
2. Remove the cardboard top.
3. Remove the polystyrene packaging
materials.