Safety Instructions; Electrical Connection - AEG A72710GNW0 Benutzerinformation

•
•
•
•

2. SAFETY INSTRUCTIONS

2.1 Installation
• Remove all the packaging and the
• Do not install or use a damaged
• Follow the installation instruction
• Always take care when moving the
• Make sure the air can circulate around
• Wait at least 4 hours before
• Do not install the appliance close to
• The rear of the appliance must stand
• Do not install the appliance where
• Do not install this appliance in areas
• When you move the appliance, lift it
Downloaded from www.Manualslib.com
Do not use water spray and steam to clean the
appliance.
Clean the appliance with a moist soft cloth. Only use
neutral detergents. Do not use abrasive products,
abrasive cleaning pads, solvents or metal objects.
Do not store explosive substances such as aerosol
cans with a flammable propellant in this appliance.
If the supply cord is damaged, it must be replaced by
the manufacturer, its Authorised Service Centre or
similarly qualified persons in order to avoid a hazard.
WARNING!
Only a qualified person must
install this appliance.
transit bolts.
appliance.
supplied with the appliance.
appliance as it is heavy. Always use
safety gloves and enclosed footwear.
the appliance.
connecting the appliance to the
power supply. This is to allow the oil
to flow back in the compressor.
radiators or cookers, oven or hobs.
against the wall.
there is direct sunlight.
that are too humid or too colds, such
as the construction appendices,
garages or wine cellars.
by the front edge to avoid scratching
the floor.
manuals search engine

2.2 Electrical connection

WARNING!
Risk of fire and electrical
shock.
• The appliance must be earthed.
• Make sure that the electrical
information on the rating plate agrees
with the power supply. If not, contact
an electrician.
• Always use a correctly installed
shockproof socket.
• Do not use multi-plug adapters and
extension cables.
• Make sure not to cause damage to
the electrical components (e.g. mains
plug, mains cable, compressor).
Contact the Authorised Service
Centre or an electrician to change the
electrical components.
• The mains cable must stay below the
level of the mains plug.
• Connect the mains plug to the mains
socket only at the end of the
installation. Make sure that there is
access to the mains plug after the
installation.
• Do not pull the mains cable to
disconnect the appliance. Always pull
the mains plug.
2.3 Use
WARNING!
Risk of injury, burns,
electrical shock or fire.
ENGLISH 15