Intended Use; Unpacking - IKA RH basic 2 Betriebsanleitung

Risk of burns! Exercise caution when touching parts of the housing and
the heating plate. The heating plate can reach dangerous temperatures.
Pay attention to the residual heat on the heating plate after switching off
the stirrer.
The device may only be transported when the heating plate has cooled
down.
› Please consider any possible contaminations and unwanted chemical reactions.
› Before placing the device in service, please ensure that the turn dial for
adjusting the speed is against the left stop, since the device will begin to run
at the last speed that was set.
› The device will automatically restart following any interruption to the power
supply.
› The device may not be transported by using an H 16 V support rod or the
power cable.
› Clicking noises may occur as a result of material expansion during heating and
cooling.
› In unsupervised and safe operation, this device may only handle or heat media
whose flash point is above the set safety temperature limit. (acc. to EN 61010-
2-010)
› Follow the safety instructions, guidelines, occupational health and safety and
accident prevention regulations.
› The device may only be opened by qualified and IKA approved experts.
› Safe operation is guaranteed only with the use of original IKA accessories.

Intended use

Use
› The IKA RH basic 2; RH basic KT/C or the IKA RH digital KT/C is a stirring
instrument with heating function. The instrument is suitable for tempering
substances which are placed on the heating plate in vessels. By means of a
built-in stirring drive and with the help of a magnetic bar within the vessel, the
12
substances can be stirred at the same time. The mixing intensity is dependent
on the motor speed and on the size of the magnetic bar. The RH basic KT/C
and RH digital KT/C also has a contact thermometer connection in compliance
with requirements of DIN 12 878 and an adjustable safety circuit.
Area of use
› Indoor environments similar to that a laboratory of research, teaching, trade or
industry area.
› The safety of the user cannot be guaranteed:
- if the device is operated with accessories that are not supplied or
recommended by the manufacturer,
- if the device is operated improperly or contrary to the manufacture's
specifications,
- if the device or the printed circuit board are modified by third parties.

Unpacking

Unpacking
› Unpack the device carefully. Any damage should immediately be reported to
the carrier (mail, rail or freight forwarding company).
Scope of delivery
› An RH basic 2 or RH basic KT/C or RH digital KT/C
› Operating instructions.