Diode Test - SATA 03022 Bedienungsanleitung

- When the input terminal is open circuited, "overload" will appear.
- Before online resistance measurement, switch off the power of the measured circuit
and fully discharge all capacitors
· Continuity test
1- Insert the black probe into the "COM" jack and the red probe into the "
2- Set the function switch to "
button until an "
3- Connect the probes to the two ends of the circuit to be measured.
4- The built-in beeper sounds when the resistance is less than about 20 Ω .
Note
Before the test, switch off the power of the measured circuit and fully discharge all
capacitors.
· Diode test
1- Insert the black probe into the "COM" jack and the red probe into the "
(Note: The polarity of the red probe is "+".)
2- Set the function switch to "
button until an "
3- Connect the red probe to the positive pole of the diode to be measured and the black
probe to the negative pole.
4- Read the approximation of the forward voltage drop of the measured diode indicated
on the screen.
03022
". And then press and hold the "function selection"
" symbol appears on the screen.
". And then press and hold the "function selection"
" symbol appears on the screen.
EN DE
- 26 -
RU KO PT JA ES
" jack.
" jack.