Bosch Readyy'y BBH2 Serie Gebrauchsanleitung Seite 28

en
Emptying the dust container
In order to achieve the best possible vacuuming
results, the dust container should be emptied after
every use.
11
Fig.
Remove the hand-held cordless vacuum cleaner from
the hand-held vacuum cleaner (see fig. 7)
Using the release button, unlock the dust container
and remove it from the motor unit.
12
Fig.
Use the handle to remove the motor protection filter
and foam filter from the dust container.
Empty the dust container.
Cleaning the filter
13
Fig.
Unlock the dust container. Remove the motor
protection filter and foam filter from the dust
container (see fig. 11 and 12)
Clean the motor protection filter and foam filter by
tapping out the dirt.
If there are heavy deposits of dirt, the filter and dust
container can be washed out.
Then wipe out the dust container with a dry cloth;
allow the filter to dry completely before re-inserting
it.
14
Fig.
a) Insert the motor protection filter and foam filter into
the dust container.
a) Fit the dust container onto the motor unit and lock it
into place.
New filters can be obtained from our after-sales
service, if required.
Cleaning the floor tool
Before carrying out any maintenance, switch off the
vacuum cleaner and disconnect it from the charging
cable.
15
Fig.
Release the brush roller using the release button and
pull it sideways out of the floor tool.
Using the groove provided, cut through threads and
hairs wound round the rollers with scissors and then
remove them.
Push the brush roller in sideways along the guide rod
in the floor tool and lock in place using the release
button.
!
Caution: The floor tool must only be put into
operation with the brush roller fitted.
Caution!
Floor tools are subject to a certain amount of wear,
depending on the type of hard floors you have
(e.g. rough, rustic tiles). Therefore, you must check
the underside of the floor tool at regular intervals.
Worn undersides of floor tools may have sharp edges
that can damage sensitive hard floors, such as parquet
or linoleum. The manufacturer does not accept any
responsibility for damage caused by worn floor tools.
Replacing the battery pack
The battery pack can be
and
16
Fig.
Release the battery pack in the direction of the
arrow and remove it from the appliance.
Insert the new battery pack and lock it in place.
A new or additional battery pack can be obtained from
our after-sales service by stating the appliance type.
!
Caution: The appliance must only be charged and
operated with a battery pack that has the same
voltage as the appliance itself.
Please refer to the voltage specified on the battery
pack and on the appliance.
Care
Before cleaning the cordless vacuum cleaner or hand-
held vacuum cleaner, they must be switched off and
disconnected from the charging cable. They can be
cleaned using a standard commercially-available plastic
cleaner.
!
Do not use a scourer, glass-cleaning agent or multi-
purpose cleaning products. Never immerse the
vacuum cleaner in water.
Disposing of the battery pack
Before disposing of the appliance, remove the battery
pack and dispose of it in an environmentally friendly
way. (see fig. 16)
removed
27