Samsung DW60H9970 Serie Benutzerhandbuch Seite 13

Dry+
8
(Control Lock)
Display
9
BU_DW9000H-00156A-07_EN.indd 13 BU_DW9000H-00156A-07_EN.indd 13
Use this option when you want to dry your dishes more completely.
The Dry+ option features a longer drying phase and higher temperatures in the
last rinse cycle, resulting in improved drying performance with slightly higher
power consumption.
*Control Lock : This option allows you to lock the buttons on the control
panel - except the Power button - so children cannot accidently start the
dishwasher by pressing the buttons on the panel. Only the Power button
remains active.
To lock or unlock the buttons on the control panel, press and hold the Dry+
(Control Lock) button for three (3) seconds.
• When the Power is On : Press and hold the "Dry+ (Control Lock)" button
for three (3) seconds.
• When the Power is Off : Push the Power button fi rst, and then press and
hold the "Dry+ (Control Lock)" button for three (3) seconds.
• Control Lock remains active until you turn it off . You cannot select cycles or
options or start the dishwasher when Control Lock is on.
Displays cycle time and remaining hours and minutes, Delay Start hours, and
check messages.
If an problem occurs during an operation, an check message is displayed with
a warning sound.
Refer to the "Information codes" section on page 33.
Control Lock indicator
- Turns on if the Control Lock is set (or the dishwasher is in the standby or
pause modes).
- Turns off while the dishwasher is operating.
- When Control Lock is on, the Control Lock indicator blinks for several
seconds if any button except the Power button is pressed.
Self Clean indicator
- Turns on when the Self Clean option is enabled (or the dishwasher is
in the standby or pause modes), but turns off while the dishwasher is
operating.
- Blinks for 5 seconds every 20 to 22 cycles.
- The cycle counter disappears when the Self Clean operation is complete
or when the dishwasher reaches the 23rd cycle without the Self Clean
cycle being used. (The Reset or Self Clean operation is not counted by
the cycle counter.)
Rinse Refi ll indicator
- Turns on if the dishwasher runs out of rinse aid (or the dishwasher is in
the standby or pause modes).
- Turns off while the dishwasher is operating.
Lack of salt indicator (*applicable models only)
- Turns on when the water softener runs out of salt. (or the dishwasher is
in the standby or pause modes.)
- Turns off while the dishwasher is operating.
English - 13
2016-09-20 2016-09-20 12:31:38 12:31:38