The Product can be stored in package in an open area for maximum 1 month if the air
temperature is 35 °С min.
Storage in packages in 2 layes is allowed.
5.3. When unpacking it, one shall make sure the showcase has all of its components in
line with section 3 hereof and that the Product itself and all of its components are in sound
condition.
When being unpacked, the Product shall be positioned horizontally, with the
maximum inclination angle to not exceed 15°.
ATTENTION! Package shall be removed with care as the showcase has glass
components. The Product is assembled on a bpard, to remove it unscrew fastening bolts.
5.4. Some details have protective coat (film) to be removed.
5.5. Before assembly clean the Product and its components.
5.6. When installing to the place of use, fix the showcase firmly by regulating its
supports. Maximum inclination shall not exceed 1°.
The Product shall not be installed on moving surfaces, including transporting vehicles.
Installation location shall ensure proper access to the product at least from two sides.
ATTENTION! Check if there is no blockage or bending of the hose for condensate
disposal.
5.7. The Products shall be used in premises within the air temperature range of +12 -
+25°С and relative humidity of 60% or below.
Do not inslolate the showcase.
The distance to the nearest heating units shall be at least two meters.
The showcase shall not be installed on a way of air ventilating streams, including from
conditioners.
ATTENTION! During transportation or storage in winter conditions the Product shall
be kept at the temperature of at least +18°С for 4 hours before commissioning.
5.8. Only the showcases taken the instructions on safety precautions and provided
with the handling rules for the Product provided in this Appliance certificate can use the
Product.
5.9. The Product shall be connected to ~220V 50 Hz mains in line with the applicable
Electrical Installations Code, Regulations for Operation of Consumer Electrical
Installations, and other regulations. Voltage supply line shall utilize wires with the section
2
of at least 1.5 mm
. It shall have overcurrent protection.
ATTENTION! Receptacle for connection of the showcase shall have a ground
contact.
5.10. After the showcase is switched on, make sure it does not produce any foreign
noises. Such noises may be the evidence of the product malfunction.
5.11. The manufacturer tuned the Product for the temperature corresponding to
calibration charts/If necessary you may change the operating temperature in the effective
volume using a microcontroller.
5.12. After commissioning the Product and upon reaching the temperature required,
put the foods precooled to the temperature of the effective volume into the showcase. The
load upon the glass shelf shall not exceed 3 kg per running meter.
EN
17